bora GP4 User Manual

EN
25
Cleaning and maintenance
www.bora.com
Fitting the stainless steel grease filter and air inlet nozzle
XX
Take hold of the stainless steel grease filter by the handle [2].
XX
Insert the stainless steel grease filter [1] into the suction opening.
XX
Ensure that the stainless steel grease filter is lying on the bottom
of the housing base. A lock is not provided or necessary.
XX
Reach into the access opening [2] of the air inlet nozzle.
XX
Insert the air inlet nozzle [1] into the centre of the suction
opening.
XX
Press the air inlet nozzle down until it clicks into place.
7.5 Cleaning the air guiding housing
Grease particles and limescale residues from cooking vapours
can settle on the surface of the air guiding housing. For this
reason, regular cleaning is essential.
The air guiding housing can be found on the bottom of the
cooktop inside the floor unit.
Opening the air guiding housing.
XX
Make sure that the cooktop and cooktop extractor are
switched off (see the “Operation” chapter).
XX
Wait until the fan level indicator shows 0 .
1 12 23 4
Fig. 7.3 Opening the air guiding housing.
[1] Rear locks
[2] Front locks
[3] Housing base
[4] Air guiding housing
XX
Hold the housing base [3] with one hand.
XX
Release both locks [1] on the back.
XX
Release both locks [2] on the front.
XX
Remove the housing base [3].
XX
Clean the air guiding housing [4] and the housing base [3] with
a mild cleaning agent.
Removing the air inlet nozzle and stainless steel
grease filter
1
2
Fig. 7.1 Removing the air inlet nozzle
[1] Air inlet nozzle
[2] Access opening
Prerequisite:
The fan level indicator shows 0 .
XX
Reach into the access opening [2].
XX
Pull the air inlet nozzle [1] up and out.
3
2
1
Fig. 7.2 Removing the stainless steel grease lter
[1] Stainless steel grease filter
[2] Handle
[3] Suction opening
XX
Take hold of the stainless steel grease filter by the handle [2].
XX
Pull the stainless steel grease filter [1] up and out of the
suction opening [3].
Cleaning the air inlet nozzle and stainless steel grease filter
i
Clean stainless steel surfaces in the polishing direction only.
i
If it is no longer possible to clean the stainless steel
grease filter completely, it must be replaced.
Manual cleaning
XX
Use a cleaner and degreaser in one.
XX
Rinse the air inlet nozzle and stainless steel grease filter with
hot water.
XX
Use a soft brush to clean the air inlet nozzle and stainless
steel grease filter.
XX
After cleaning, rinse the air inlet nozzle and stainless steel
grease filter well.
Cleaning in the dishwasher
XX
Rinse the air inlet nozzle and stainless steel grease filter with a
rinsing program at a maximum of 65°C.

bora GP4 Specifications

General

Brand	bora
Model	GP4
Category	Cooktop
Language	English