bora GP4 User Manual

EN
6
Safety
www.bora.com
XX Check the information on the identification plate
and in the event of deviations, do not connect the
appliance.
XX Conduct all work extremely attentively and
conscientiously.
XX Do not connect the appliance to the mains until
the duct system has been installed or the
recirculation filter has been fitted.
XX Only use the connection cables supplied. Where
necessary these are included in the scope of
delivery.
XX Do not use the appliance until installation is
complete. This is the only way to ensure safe
operation.
ÿ
DANGER!
Risk of electric shock from damaged appliance
A damaged appliance can cause an electric shock.
XX Check the appliance for visible damage prior to
installation.
XX Do not install or connect any damaged
appliances.
XX Do not operate any damaged appliances.
2.4.1 Safety instructions – cooktop
extractor installation
ÿ
DANGER!
Risk of electric shock from incorrect stripping
of cables
Incorrect stripping of the connection cable to
external switching devices results in a risk of
electric shock.
XX Ensure that the stated stripping lengths are
adhered to.
ÿ
WARNING!
Risk of injury due to moving fan wheel
There is a risk of injury while the fan is turning.
XX Only install the device with the power
disconnected.
XX Connect both sides of the fan to the duct
system before commissioning.
Special safety instructions for the planning of
extractor systems
ÿ
DANGER!
Risk of smoke inhalation
When the cooktop extractor is used in exhaust
air mode, it draws in air from the room it is
installed in and from neighbouring rooms. If there
is insu󹩴cient air supply, low pressure will occur.
When used at the same time as a replace that
is dependent on the air in the room, noxious
gases can be sucked into the living areas from the
chimney or outlet shaft.
XX Make sure that there is always a sufficient air
supply.
XX Only use reliable, tried-and-tested switching
devices, (e.g. window contact switch, low
pressure warning device) and have them
approved by a qualified expert (certified chimney
sweep).
Ducting connected to wall sleeves
In the case of straight ducting and a distance
< 900mm between the fan and wall sleeve, a
safety guard must be provided for (available as an
accessory).
2.4.2 Safety instructions for cooktop
installation
ÿ
DANGER!
Risk of electric shock from incorrect mains
connection
Connecting the appliance to the mains incorrectly
poses a risk of electric shock.
XX Make sure that the appliance has a fixed
connection to the mains voltage.
XX Make sure that the appliance is connected to a
properly installed protective conductor system.
XX Make sure that technical equipment is provided
to enable all of the appliance’s poles to be
disconnected from the mains with a contact
opening width of at least 3 mm (LS switch and
automatic circuit breakers, fuses, contactor).

bora GP4 Specifications

General

Brand	bora
Model	GP4
Category	Cooktop
Language	English