Borri INGENIO COMPACT - Installation

Монтаж и пуск INGENIO COMPACT ИБП 10÷20 кВА
Installation and start-up of INGENIO COMPACT 10÷20 kVA
OMS90050 РЕД. / REV.A
45
2.3.4 Installation
The product must be installed in strict compliance with the instructions contained in the
technical back-up documentation, including the present safety instructions. In particular, the
following points must be taken into account:
 The product must be placed on a base suitable to carry its weight and to ensure its
vertical position;
 The UPS must be installed in a room with restricted access, according to standard
CEI EN62040-1;
 Never install the equipment near liquids or in an excessively damp environment;
 Never let a liquid or foreign body penetrate inside the device;
 Never block the ventilation grates;
 Never expose the device to direct sunlight or place it near a source of heat.
Special environmental conditions
The UPS is designed for normal climatic and environmental operating conditions as
defined in the technical specification: altitude, ambient operating temperature,
relative humidity and environmental transport and storage conditions. It is necessary
to implement specific protective measures in case of unusual conditions:
 harmful smoke, dust, abrasive dust;
 humidity, vapour, salt air, bad weather or dripping;
 explosive dust and gas mixture;
 extreme temperature variations;
 bad ventilation;
 conductive or radiant heat from other sources;
 strong electromagnetic fields;
 radioactive levels higher than those of the natural environment;
 fungus, insects, vermin.
Use authorized personnel only
All transport, installation and start-up operations must be carried out by qualified and
trained personnel.
The installation of the UPS must be carried out by authorized personnel, in
compliance with national and local regulations.