Bosch AMAX 4000 - Quick Keypad Operations Instructions

Quick Keypad Operations Instructions
The following table shows an overview of the quick keypad operations and the corresponding
user permissions. For information on changing codes and defining user permission levels,
please refer to Codes, page 24.
Function Command
Default User Code = 2580
D A B S M
1
M
2
I
N
Arm/Disarm
AWAY Arm [code] + [#] / [#] for 3 sec. (quick arm) √ √ √ √ √ √ √
AWAY Arm All Areas (only
on master keypad)
[code] + [0] [0] + [#] √ √ √ √ √ √ √
Direct AWAY Arm (only on
master keypad
[code] + [2-digit area no.] + [#] √ √ √
STAY Arm [code] + [*] / [*] for 3 sec. (quick arm) √ √ √ √ √ √ √
STAY Arm All Areas (only
on master keypad)
[code] + [0] [0] + [*] √ √ √ √ √ √ √
Direct STAY Arm (only on
master keypad
[code] + [2-digit area no.] + [*] √ √ √
Disarm [code] + [#] √ √ √ √ √ √
Disarm All Areas (only on
master keypad)
[code] + [#] √ √ √ √ √ √
Display
Display Info (Fault/Tamper
Analysis)
[code] + [2] [1] + [#] √ √ √
Bypass
Bypass/Unbypass Zone [code] + [3] [1] + [#] + [2-digit zone no.]
+ [#]
√ √ √ √ √
Bypass Fault/Tamper [code] + [3] [4] + [#] √ √ √
Reset
Reset Fault/Tamper (In
some country versions only
the installer can reset a
tamper alarm)
[code] + [6] + [#] √ √ √
Macros
Record Macro 1 [code] + [8] [1] + [#] + operation + [#]
for 3 sec.
√ √ √ √
2.4
10 en | Short information AMAX
2014.09 | 03 | F.01U.295.569 User Guide Bosch Sicherheitsysteme GmbH