Playing Macros
How to Play a Macro
There are two methods to play a macro.
Method 1:
4 Enter your code and press the number on which the macro is assigned for three seconds.
(Possible numbers are 1, 2 and 3.)
P The system beeps and the operation which is assigned to the macro is executed
automatically.
Method 2 (Quick Play):
4 Press the number on which the macro is assigned for three seconds. (Possible numbers
are 1, 2 and 3.)
P The system beeps and the operation which is assigned to the macro is executed
automatically.
Please contact your installer to enable/disable this function.
Notice!
Please note that the play function has to be enabled/disabled individually for every user.
Please refer to Add/Change User Codes, page 24.
Example of Playing a Macro: Bypassing a Zone
This example shows how to play macro 1 for bypassing zone 3 (see the example in Recording
Macros, page 22).
4 Enter your code and press [1] for three seconds.
The system beeps and the macro 1 is executed automatically.
P If zone 3 was unbypassed before playing macro 1, it is bypassed now.
P If zone 3 was bypassed before playing macro 1, it is unbypassed now.
8.2
AMAX Macros | en 23
Bosch Sicherheitsysteme GmbH User Guide 2014.09 | 03 | F.01U.295.569
To Next Page
Loading...
