Arming and Disarming the System
Arming the System
Notice!
When the number of incorrect code entries on the keypad reaches a specified limit
(configured by the installer), the keypad will automatically lock for 180 seconds and an alarm
is reported. If the keypad is idle for one minute, the system will automatically exit from any
operational mode.
Arming in AWAY Mode
The AWAY Mode is used to arm the premises to detect a would-be intruder, when you leave
the premises and require that all zones are activated in a ready state.
Keypad Arming
There are two methods to arm your system in AWAY mode.
Method 1:
4 Enter your code and press [#].
P The system beeps twice, the AWAY indicator flashes slowly and exit time starts. After the
exit time, the AWAY indicator is lit.
Method 2 (Quick Arm):
4 Press and hold [#] until the system beeps twice.
P The AWAY indicator flashes slowly and exit time starts. After the exit time, the AWAY
indicator is lit.
Please contact your installer to enable/disable this function.
Telephone Remote Arming
Users can use a telephone to arm the system.
1.
Dial the control panel number.
The control panel answers the call and issues a long beep.
2.
Press [#].
P When the panel receives the signal it confirms the arming of the control panel with a high
tone.
Please contact your installer to enable/disable this function.
Notice!
Telephone remote arming is only possible when the system has only one assigned area.
Key Switch Arming
Users can use a key switch to arm the system.
4 Activate the key switch.
P The AWAY indicator flashes slowly and exit time starts. After exit time, the AWAY indicator
is lit.
Please contact your installer to enable/disable this function.
3
3.1
3.1.1
14 en | Arming and Disarming the System AMAX
2014.09 | 03 | F.01U.295.569 User Guide Bosch Sicherheitsysteme GmbH
To Next Page
Loading...
