RADION RF Keyfob Arming
Users can use a RADION RF keyfob to arm the system.
4 Press the arming button of the RADION RF keyfob.
P The AWAY indicator flashes slowly and exit time starts. After exit time, the AWAY indicator
is lit.
Please contact your installer to enable/disable this function.
Arming in STAY Mode
The STAY Mode is used to arm the perimeter and unused areas of the premises to detect a
would-be intruder, while at the same time being able to move freely within an area that is
automatically isolated.
Keypad Arming
There are two methods to arm your system in STAY mode.
Method 1:
4 Enter your code and press [*].
P The system beeps twice, the STAY indicator flashes slowly and exit time starts. After the
exit time, the STAY indicator is lit.
P The lights corresponding to all zones programmed as automatically isolated zones
(Interior Instant Zone) begin to flash and continue until the exit time is finished.
Method 2 (Quick Arm):
4 Press and hold [*] until the system beeps twice.
P The STAY indicator flashes slowly and exit time starts. After the exit time, the STAY
indicator is lit.
Please contact your installer to enable/disable this function.
RADION RF Keyfob Arming
Users can use a RADION RF four button keyfob to arm the system via the third button.
4 Press the third button of the RADION RF four button keyfob.
P The STAY indicator flashes slowly and exit time starts. After the exit time, the STAY
indicator is lit.
Please contact your installer to enable/disable this function.
Forced Arming
Arming the system when a zone is not sealed is known as forced arming.
If the AWAY indicator is not lit and a long beep sounds when you attempt to arm the system in
AWAY mode, then forced arming is not permitted. In this case, you have to seal all zones or
manually isolate them before you can arm the system.
Please contact your installer to enable/disable this function.
3.1.2
3.1.3
AMAX Arming and Disarming the System | en 15
Bosch Sicherheitsysteme GmbH User Guide 2014.09 | 03 | F.01U.295.569
To Next Page
Loading...
