Codes
Add/Change User Codes
This function is used if you want to add a code for a new user or if you want to change the
user permission levels or the code of an existing user. Only master users can add or change
user codes.
Notice!
This function can only be operated with a text keypad.
How to Add/Change User Codes
1. Enter your code + [5] [4] and press [#].
The system beeps twice and the STAY and AWAY indicators start flashing.
2. Enter a user number (1-64) and press [#].
The current user permission level for this user is shown. (Default for user number 2-64 is
15-Not used)
3. Select the desired user permission level. You can choose the following user permission
levels for a code:
0-Master1 code
1-Master2 code
2-Super code
3-Basic code
4-Arming code
5-Duress code
15-Not used
Please refer to Quick Keypad Operations Instructions, page 10 for a description of the user
permission levels.
4. Press [#] twice.
The available areas are shown. Already selected areas are checked.
5. Use [▲] and [▼] to display all areas.
6. Enter the two-digit area number you wish to enable for the user or enter [0] [0] if you
want to enable all areas.
The enabled area is checked.
7. Repeat step 6 if you want to enable multiple areas for the user.
8. Press [#].
The available macros are shown. Already selected macros are checked.
9. Enter the two-digit macro number you wish to enable for the user.
The enabled macro is checked.
10. Repeat step 9 if you want to enable multiple areas for the user.
11. Press [#].
12. Enter a (new) code with a default length of four digits. (A code with five or six digits is
also possible but has to be enabled by the installer.)
13. Press [#].
14. Optionally enter a keyfob ID manually.
Or
Press and hold [*] for three seconds to switch to the KEYFOB ID: AUTO menu.
Trigger the keyfob to give alarm once.
9
9.1
24 en | Codes AMAX
2014.09 | 03 | F.01U.295.569 User Guide Bosch Sicherheitsysteme GmbH
To Next Page
Loading...
