Bosch CL300 - Page 49

Operation
FlexibleAutomation
3−5
3.3 Operating Modes
The CL300 can operate in the RUN and STOP modes, which can be set on the
ZE300/301 central processing unit.
The start−up performance of the CL300 after power−on or from the stop state can
be determined in the OM7 or OM8 Organizational Modules provided for that pur
pose.
3.3.1 RUN
In RUN mode the following sequence is performed:
D The user program is executed in cyclic, interrupt− or time−controlled man
ner.
D The timers started in the program time out.
D The inputs/outputs are enabled.