DS7200V2-UK Installer's Guide Copyright 2007 Bosch Security Systems, Inc. P/N: 4998152533-02 Page 101
PART IV: CONTROL PANEL PROGRAMMING
50.0 RF Keypads
The control panel supports up to four RF keypads. Each keypad has two programming parameters. The RF keypads report
low battery, tamper, etc. by transmitter number.
You must exit control panel programming in order to enter RF ID codes. Add RF ID codes after you complete your
programming session. See
Adding RF ID Codes on page34 for more information.
There is no RF keypad currently available.
RF Keypad Rcvr 1 DBus Address Transmitter Number Rcvr 2 DBus Address Transmitter Number
1 52 255 60 247
2 53 254 61 246
3 54 253 62 245
4 55 252 63 244
Table 37: RF Keypad Data Bus Addresses
RF Keypad # Options
• Address:
−
RF Keypad 1: 2930
− RF Keypad 2: 2932
− RF Keypad 3: 2934
− RF Keypad 4: 2936
• Default: 0
• Selections: 0, 2, 4, 6
Enter This Data Digit to Select Options
RF Keypad # Options 0 1 2 3 4 5 6 7 8 9 10
11
12
13
14
15
No Options Selected
•
Reserved
Belongs to Receiver 2
•
•
Supervised
•
•
Reserved
• Belongs to Receiver 2: If this option is enabled, RF Receiver 2 performs ID and monitoring functions for the keypad. If this
option is disabled, the keypad belongs to Receiver 1.
• Supervised: If this option is enabled, the control panel generates missing reports if it does not hear from the RF keypad.
RF Keypad # Area
• Address:
−
RF Keypad 1: 2931
− RF Keypad 2: 2933
− RF Keypad 3: 2935
− RF Keypad 4: 2937
• Default: 0 (Disabled)
• Selections:
−
0 = Disabled (no area assigned)
− 1 = Assign RF Keypad to Area 1
− 2 = Assign RF Keypad to Area 2
− 3 = Assign RF Keypad to Area 3 (DS7240V2 only)
− 4 = Assign RF Keypad to Area 4 (DS7240V2 only)
To enable an RF keypad, assign it to an area. To disable an RF keypad, enter a 0 at this parameter.
To Next Page
Loading...
