Bosch DS7220V2 - Dx4010 I;Dx4010 DB9 Connector; 21 Network Interface Module (DX4020); DX4020 Overview; DX4020 Addressing

Page 28 P/N: 4998152533-02 Copyright  2007 Bosch Security Systems, Inc. DS7200V2-UK Installer's Guide
PART II: SYSTEM INSTALLATION AND SETUP
20.7 DX4010i/DX4010 DB9 Connector
The DB9 pins are configured as shown in Table 14
and
Figure 44.
DB9 Pin Number Pin Configuration
1 DCD
2 RxD
3 TxD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI
Table 14: DB9 Pin Configuration
12345
6789
Figure 44: DB9 Connector Layout
21.0 Network Interface Module (DX4020)
Firmware revision 2.10 or greater is required
for network communication.
21.1 DX4020 Overview
The DX4020 Network Interface Module (NIM)
provides bi-directional communication over an
Ethernet network. It can also be used for remote
programming sessions with RPS (Remote
Programming Software).
21.2 DX4020 Addressing
Set the DIP Switch address to 134 when using the
DX4020 for network communication.
Network Communication DIP Switch Setting
Example:
Module Address 134
= Switch OPEN (Up)
=
= Switch CLOSED (Down)
=
OPEN
12345678
DX4020 Mounting Locations
Figure 45: Network Communication DIP Switch Setting
21.3 DX4020 Installation
Failure to follow the mounting instructions in
this document can result in damage to the
module.
The DX4020 contains static-sensitive
components and must be handled with care.
Follow anti-static procedures when handling
this module.
Mount the DX4020 to the back wall of the control
panel’s enclosure. See
Figure 46.
DX4020 Mounting Locations
DX4020 Mounting Locations
INSTALLER
PO4
PO3
PO2
Figure 46: DX4020 Mounting Locations