Bosch DS7220V2 - Table 25: Key;Character Assignments

Page 62 P/N: 4998152533-02 Copyright  2007 Bosch Security Systems, Inc. DS7200V2-UK Installer's Guide
PART IV: CONTROL PANEL PROGRAMMING
Area Name Text
• Address:
−
Area 1 Name: 1394-1425
− Area 2 Name: 1458-1489
− Area 3 Name (DS7240V2 only): 1522-1553
− Area 4 Name (DS7240V2 only): 1586-1617
• Default:
−
Area 1: Area 1 Name Text
− Area 2: Area 2 Name Text
− Area 3 (DS7240V2 only): Area 3 Name Text
− Area 4 (DS7240V2 only): Area 4 Name Text
• Selections: See Table 25
Enter up to 16 characters to describe each area.
Key Character
0 + - 0 * / \ [ ] = > < # §
1 Space . 1 ? ! , @ _ & ~ : ; " ( ) ' ¿ ¡ % £ $ ¥
2 A B C a b c 2 Å Ä Ã å ä á à â ã α β Ç ç
3 D E F d e f 3 É Æ ë é è ê æ ∆ Φ δ ε
4 G H I g h I 4 ï í î ì Γ γ η ι
5 J K L j k l 5 Λ κ λ
6 M N O m n o 6 Ö ö Ñ ñ Ø Õ ø ó ò ô õ Ω µ ν ω
7 P Q R S p q r s 7 Π Σ π ρ σ
8 T U V t u v 8 Ü ü ú ù û Θ Υ θ τ υ
9 W X Y Z w x y z 9 ÿ Ξ Ψ ξ χ ψ ζ
* Moves to the address before the text block.
# Moves to the address after the text block.
A Moves cursor to the previous character
position in text block.
C Moves cursor to the next character position in
text block.
Table 25: Key/Character Assignments
The following keys are not used in text programming and produce an error tone when pressed:
• [B] Key
• [On]
• [Off]
• [Perimeter Only]
• [No Entry]
• [Bypass]
• [System Reset]
Press the [1] key once to clear a character space or to enter a blank space.