Bosch FLEXIDOME multi 7000i IR - Preparation; Network and PoE++

FLEXIDOME multi 7000i IR Planning information | en 13
Bosch Security Systems B.V.
Installation manual
2023-02 | 02 |
Quantity Component
1 Quick installation guide
1 Safety information
3 Installer UX labels
4.3 Preparation
Before installation, prepare and plan the installation process and materials needed.
Pre-requisites
– Remove the components from the box. Make sure that all parts are included and are not
damaged.
– The necessary material and equipment:
– 4 screws M4 or M5 and mounting plugs M4 or M5 are necessary. For installation with
conduit (NDA-7051-CA), 5 screws M4 or M5 and mounting plugs M4 or M5 are
necessary.
– Appropriate size power drill.
– Screwdriver and bit holder for TR20 bit, or use the provided TR20 Allen key.
– microSD card (optional)
Note: Bosch recommends the use of industrial microSD cards with health
monitoring.
– Wireless USB dongle (NCA-WLAN) for wireless commissioning (optional) - available
2022.
4.4 Network and PoE++
i
Notice!
Camera supports PoE++ and PoE+
PoE802.3bt Type 3 Class 5 with operating temperature -50°C to +55°C / -58°F to +131°F)
PoE802.3at Type 2 Class 4 with operating temperature -20°C to +55°C / -4°F to +131°F)
Power-over-Ethernet Plus Plus (PoE++) can be connected at the same time as a 24VAC power
supply. If auxiliary power (24VAC) and PoE++ is applied simultaneously, the camera draws its
power from PoE++ by default, and seamlessly switches to auxiliary input if PoE++ fails.
When PoE++ returns, the camera seamlessly switches back to PoE++ as its default power
source.
The camera has an integrated heater. The heater works only when PoE802.3bt Type 3 Class 5
is used. In this case, the camera functions in lower temperature (-50°C / -58°F).
Cables
For cable requirements, refer to Wiring the camera base, page 22 .