14 en | Installation FLEXIDOME multi 7000i IR
2023-02 | 02 |
Installation manual
Bosch Security Systems B.V.
5 Installation
5.1 Installing the mounting plate
The mounting plate is used to fix the camera to a flat surface. It offers different holes and
slots for a variety of fixing options.
1 PIP
Mounting holes for installation with
NDA-7050-PIPW. Required screws are
provided with NDA-7050-PIPW.
2 A
Mounting holes for 4inch or 4S
electrical box installation. There are
four mounting holes available on the
mounting plate, but you need only two
for the installation. You can install the
mounting plate in different
orientations.
3 B
Mounting holes for standard wall or
ceiling installation. Use four screws. If
required, use plugs (for concrete
walls/ceilings).
4 C
Mounting holes for double gang box
installation. Align the mounting plate
with the four screw holes in the
electrical gang box.
5 D
Mounting holes for single gang box.
Align the two slotted holes on the
mounting plate with the two screw
holes in the electrical gang box.
Installation options
The camera has two configurations for surface mounting:
– Refer to
Installing the mounting plate without conduit, page 15
, if the wires are not on
the outside of the surface.
– Refer to
Installing the mounting plate with conduit (NDA-7051-CA), page 15
, if the wires
are on the outside of the surface.
Additionally, the camera can cover various mounting options when combined with the
available accessories. Refer to
Optional mounting accessories, page 28
for the available
accessories.
To Next Page
Loading...
