Bosch FLEXIDOME multi 7000i IR - Setting the Position of the Multi-Imager Lenses; Panning Each of the Four Lenses

FLEXIDOME multi 7000i IR Installation | en 25
Bosch Security Systems B.V.
Installation manual
2023-02 | 02 |
5.3 Setting the position of the multi-imager lenses
You can set the position of each multi-imager lens individually to achieve maximum flexibility.
You can do the following 4-axis lens adjustments:
1. Panning each of the four lenses over the ring, page 25 : 0º to 360º
2. Tilting each of the four lenses, page 26 : 0º to 105º
3. Rotating each of the four lenses, page 26 : -20º to 20º
4. Rolling each of the four lenses, page 27 : -90º to 90º
3
5.3.1 Panning each of the four lenses over the ring
1. Pan each of the four lenses to set the position that you need. You can pan 0° to 360° over
the integrated transportation ring in the camera.
360º
2. To set the camera in an optimal 360° overview position, pan each of the four lenses so
that the grey triangle icons match the screws. For an optimal 360° overview position, you
also need to tilt the lenses at least 20° to have overlapping images. Refer to Tilting each
of the four lenses, page 26 .