Bosch FLEXIDOME multi 7000i IR - Tilting Each of the Four Lenses; Rotating Each of the Four Lenses

26 en | Installation FLEXIDOME multi 7000i IR
2023-02 | 02 |
Installation manual
Bosch Security Systems B.V.
5.3.2 Tilting each of the four lenses
1. Tilt the each of the four lenses to set the position that you need. You can tilt 0° to 105°.
0º ~ 105°
x2
2. To set each of the four lenses at 90° tilt, to let the lens face straight down in ceiling
installations, make sure that the white dot in the middle of the larger lens holder meets
the edge of the smaller lens holder.
3. Do not tilt each of the four lenses any further than until the white dot on the edge of the
lens holder meets the white triangle. If you tilt any further, you might see a partly blurry
image. Use this position only in specific use cases or when you need the lens to fully
zoom in.
4. To obtain 360° overlapping images, make sure to have a tilt angle from the ceiling of at
least 20° up to 62°:
– 20°: bottom half of the images shows overlap
– 62°: full 360° overview with side by side overlap and without blind spots
5.3.3 Rotating each of the four lenses
1. Rotate each of the four lenses on the camera base to set the position that you need. You
can rotate -20º to 20º.