Bosch FLEXIDOME multi 7000i IR - Installing the Camera Base; Before the Installation

FLEXIDOME multi 7000i IR Installation | en 17
Bosch Security Systems B.V.
Installation manual
2023-02 | 02 |
5.2 Installing the camera base
5.2.1 Before the installation
1. Remove the camera base from the box.
2. If the installation of the mounting plate was done with the conduit, remove the door on
the camera base as shown in the image. Keep the screw and lid.
Local storage
i
Notice!
Bosch recommends the use of industrial micro SD cards with health monitoring.
1. If necessary, install a micro SD card in the micro SD slot.
2. Press the micro SD card firmly until it latches into place in the slot.
3. To remove the card, press it into the slot until it unlatches again. Then, remove it from the
SD slot.