Bosch GLM 100-25 C - Stake-Out Function

30 | English
Stake-Out Function
In the stake-out function, the reference level is the marking shown in the display.
The reference level is not the edge of the measuring tool.
1
2
3
1x 0,5 m
2x 0
,
5 m
m
0.500m2x
1.000
m
0.500 m
2x
1.000
m0.500
+
_
The stake-out function repeatedly measures
a defined length (distance). These lengths
can be transferred to a surface, for example
to enable material to be cut into pieces of
equal length or to install stud walls in a dry-
wall construction. The minimum adjustable
length is 0.1m and the maximum length is
50m.
m
0.500 m
2x
1.000
m0.500
+
_
Press the button to open the Functions menu.
Select stake-out function and confirm the selection
with the button.
Press the button to set the required length.
Use the button or the button to set the required
length.
Press and hold the button or the button to change
the length by larger increments.
Press the button to start the stake-out function and distance yourself slowly from
the starting point.
The measuring tool continuously measures the distance to the starting point. The
defined length and the current measured value are thereby displayed. The lower or up-
per arrow displays the shortest distance to the next or previous marking.
With continuous measurement, you can also establish a measured value as a defined
length by pressing and holding the button.
1 609 92A 7E1 | (14.12.2021) Bosch Power Tools