Bosch HPC 400 Installation Instructions For Contractors

BOSCH
1 Key to symbols and safety instructions
1.1 Key to symbols
Warnings
&
Warnings in this document are identified by a warning
I triangle printed against a grey background.
• Keywords at the start of a warning indicate the type and
seriousness of the ensuing risk if measures to prevent
the risk are not taken .
The following keywords are defined and can be used in this document :
• NOTICE indicates a situation that could result in damage to property
or equipment.
CAUTION indicates a situation that could result in minor to medium
injury.
WARNING indicates a situation that could result in severe injury or
death .
• DANGER indicates a situation that will result in severe injury or
death .
Important information
[]
This symbol indicates important information where
1 there i~ no risk to people or property.
Additional symbols
Table 1
1.2 General safety instructions
These installation instructions are intended for
p1umbers, heating engineers and electricians.
~ Read the installation instructions (heat appliances,
modules, etc.) before installation.
~ Observe safety instructions and warnings.
~ Observe national and regional regulations,
technical rules and guidelines .
~ Keep a record of any work carried out.
Determined use
~ The product must only be used for controlling
heating systems in single-family or multi-family
homes.
Any other use is considered inappropriate. Any
damage that may result is excluded from liability.
Installation, commissioning and maintenance
Installation, commissioning and maintenance must
only be carried out by a competent person.
~ Never install the product in wet rooms.
~ Only install genuine spare parts.
Key to symbols and safety instructions
Electrical work
Electrical work must only be carried out by qualified
electricians.
~ Before carrying out electrical work:
- Isolate all poles of the mains voltage and secure
against reconnection.
- Using suitable means, test that the power supply
is disconnected.
~ Never connect the product to mains voltage.
~ Also observe connection diagrams of other system
components.
Handover to the user
When handing over the heating system, explain the
operating conditions to the user.
~ Explain how to operate the solar system, with
particular emphasis on all safety-related actions.
~ Explain that conversions and maintenance must
only be carried out by an authorised contractor.
~ Point out the need for inspections and maintenance
for safe and environmentally friendly operation .
•
The installation and operating instructions must be
given to the user for keeping.
Damage caused by frost
The system can freeze if it is switched off:
~ Observe the notices regarding frost protection_
• Due to the additional functions, e.g. DHW heating or
anti-seizing protection, the system should always
be left on.
~ Correct any faults immediately.
2 General
These are original instructions. Translation is not allowed without
approval by the manufacturer. .
[]
Installation may only be carried out by a trained
1
contractor . The installer must observe local provisions
and regulations as well as the information in the
installation and operating instructions .
2.1 Declaration of Conformity
(
~ The design and operation of this product comply with
~ European Directives and the supplementary national
requirements. Its conformity is demonstrated by the CE
marking .
You can ask for a copy of the declaration of conformity for this product.
For this see the contact address on the back cover of these instructions.
HP(>100-6
7
20R2, 17212017,01) 3

Bosch HPC 400 Specifications

General

Brand	Bosch
Model	HPC 400
Category	Control Panel
Language	English