Bosch HPC 400 Installation Instructions For Contractors

COMMISSIONING
~ BOSCH
4.4 Overview of the service menu
--------
heater
System data
c ooling
P ri o ri ty heat i ng
DHW settings
complete
Diagnos is
Table 9 Overview of the service menu
5
COMMISSIONING
and.ifnecessary .adjustthe ----rortheauxiliaryheater:-- -- ---- -- -~ 15
The settings that apply to the entire heating system. e.g. minimum outside temperature and building type. This 17
menu contains additional settings for heating/cooling circuit 1.
Heating circuit 1 determines how the system behaves . If there is no heat requirementfor heating circuit 1. no heat 18
requirements for other circuits are handled either.
ng Circuit - specific settings for installed heating/cooling circuits 1 to 4. e.g. frost protection and 18
and save settings .
- ---- - ----
System diagnosis :
I
'. Perform function test of individual actuators (e .g. pumps) .
Compare set and actual values .
Call up current faults and the fault history .
Call up the software versions of all BUS nodes .
Additional functions :
Enter contact address .
•
Reset different settings .
and configuration
26
26
• Calibrate the time .
---------~
5.1
General commissioning of the user interface
[I]
Before comissio n ing:
1 ~ Turn on and set coding correctly on all additionally
install ed mo d ules (-7 Technical documentation of
the particular module) .
&
, CQ)'
~ Turn the selector to set whether a buffer cylinder is i nstalled
or not and then press the selector to confirm .
~ Turn and press the selector to start (Y es) or to skip the
configuration wizard ( No ).
~ When the configuration wizard is started. the user interface I
automatically recognises which BUS nodes are installed in the
system (system analysis) and adjusts the menu and the I
factory defaults to the current system. J
~ Perform system commissioning (~Chapter 5. 2) .
Table 10 General settings at commissioning
8 HPC~OO - G -2082 1 772 (2017107)

Bosch HPC 400 Specifications

General

Brand	Bosch
Model	HPC 400
Category	Control Panel
Language	English