18 en | Installation MAP 5000
2016.06 | 17 | F.01U.168.332 Installation manual Bosch Sicherheitssysteme GmbH
Mounting the enclosure
Element Description
1 Mounting hole
2 Hole for screw to secure wall tamper plug
Mounting an edge protection profile (optional)
For an installation according to the regulations of NFa2p AFNOR certification, it is necessary
to mount an edge protection profile on the upper edge of the MAP enclosure.
The edge protection profile can be ordered at http://eshop.wuerth.de/en/US/EUR/ with the
article number 09610027.
1. Mount the edge protection profile on the upper edge of the MAP enclosure from the left
to the right. Ensure not to leave gaps at the cut-outs.
2. Cut off the overlaying edge protection profile on the right side of the enclosure.
To Next Page
Loading...
