MAP 5000 Installation | en 21
Bosch Sicherheitssysteme GmbH Installation manual 2016.06 | 17 | F.01U.168.332
IPP-MAP0005 power supply ratings label
1. Mount the AC terminal block to the enclosure back wall into the corresponding mounting
holes as shown in the figure below and secure it with the supplied screws (1).
2. Plug the terminal block connected to the AC terminal block into the power supply as
shown in the figure below (2).
3. Connect the ground wire to the ground connection point of the enclosure back wall as
shown in the figure below (3).
To Next Page
Loading...
