10.3 Identification
The respective type designation of the complete product results from the se‐
lected options. These designations are printed to the nameplate along with
other product data.
Every product by Bosch Rexroth is clearly identifiable by the designation and
the serial number.
1 Type of machine
2 Designation of origin
3 Change status
4 Type designation
5 Manufacturing plant
6 CE mark of conformity
7 Degree of protection by housing
8 Mass
9 Thermal temperature class
10 Insulation system
11 Maximum input voltage
12 Maximum speed
13 Rated speed / company address
14 Rotor inertia
15 Rated current
16 Manufacturing date
17 Rated torque
18 Maximum power
19 Rexroth barcode
20 Serial number
21 Material number
Fig. 10-1: BA1N type plate example
BA1N energy storage devices are each delivered with 2 type plates. Attach
the second type plate to an easily visible position at the machine. This way,
you can read the data at any time without having to work in areas that are
difficult to access and where the energy storage device may be attached.
Attach type plate
1. Find an easily accessible position at the machine.
2. Clean the adhesive area and make sure the surface is free from grease.
3. Remove the peel-off foil from the rear side of the type plate and attach
the type plate with the peel-off foil to the cleaned adhesive area.
4. If the machine or the type plate is not recoated after it has been attach‐
ed to the machine, the peel-off foil can be removed. Otherwise, remove
48/73
Handling and transport
BA1N Kinetic Energy Buffer
Bosch Rexroth AG R911393264_Edition 01
To Next Page
Loading...
