the peel-off foil only after painting has been completed to ensure reada‐
bility.
Before contacting Bosch Rexroth, always specify the full type
designations and serial numbers of the products involved.
10.4 Transport and storage
10.4.1 General notes
Damage or injuries and loss of the warranty
due to improper handling!
● Protect the products against moisture and corrosion.
● Avoid putting the products under mechanical load. Do not throw, tilt or
drop the products.
● Only use lifting equipment suitable for the weight of the BA1N energy
storage device.
● Never lift the BA1N energy storage device by the fan housing.
● Use suitable protective devices and wear protective clothing when trans‐
porting the device.
10.4.2 Transport instructions
To protect the BA1N energy storage device against dirt, dust, etc., Bosch
Rexroth recommends transporting it
● until it has reached its intended installation site and
● until it is actually installed in the machine
in its original packaging in which the BA1N energy storage device is delivered
by Rexroth.
To lift the BA1N energy storage device out of the transport crate or to install it
in the machine, use the attached lifting eyebolts.
The lifting eyebolts at least meet the requirements of DIN 580. Before each
transport, ensure that the lifting eyebolts have been screwed down fully to the
contact surface and that your selected lifting equipment and lifting method
does not overstress the lifting eyebolts.
Please comply with DIN 580 on the transport of the BA1N energy
storage device using the attached lifting eyebolts. Non-observ‐
ance of the information in this standard can cause overstress to
the lifting eyebolts and result in personal injury and/or product
damage.
Based on DIN EN 60721-3-2, the tables below specify classifications and lim‐
it values which are allowed for our products while they are transported by
land, sea or air. Refer to the detailed description of the classifications to take
all of the factors which are specified in the particular class into account.
Allowed classes of environmental conditions during transport acc. to DIN EN
60721-3-2
Classification type Allowed class
Classification of climatic environmental conditions 2K2
BA1N Kinetic Energy Buffer 49/73
Handling and transport
R911393264_Edition 01 Bosch Rexroth AG
To Next Page
Loading...
