Bosch Rexroth CS660 - Material Catch Test

16/27
Bosch Rexroth Canada I March 2021 ı Revision 3.0
STEP 3
Discharge more
liquid for better
calibration accuracy
STEP 1
Enter desired rate speed
Duration
Press ‘Continue’
STEP 2
Measure material
Enter the value
Press ‘Continue’
2.6 Material Catch Test
2.6.1 Solid Material Catch Test
1. Tap on solid, prewet or anti-icing icon to enter into the material calibration screen.
2. Place an adequate catch container under the spreader discharge chute.
3. A wt/rev (kg/rev or lb/rev) will be calculated and displayed on the bottom right of the screen.
4. Repeat this procedure for all solid materials (use the left and right arrows to select material types).