Bosch Rexroth CS660 - Table of Contents

2/27
Bosch Rexroth Canada I March 2021 ı Revision 3.0
Table of Contents
Bosch Rexroth Canada Corp. reserves the right to revise this information at any time and for any reason and reserves the
right to make changes at any time, without notice or obligation, to any of the information contained in this piece of
literature. The information shown in this manual features the latest version of software as of publication; therefore, some
features shown will not exist on older versions of software in use by some customers.
Please check for updates at: www.boschrexroth.ca/cs
1
Setup Screen Layout
3
2
Set up for Basic Operation
4
2.1
System Configuration
4
2.2
Inputs and Outputs Configuration
7
2.3
Ground Speed Calibration
9
2.4
Valve & Sensors Set up
9
2.5
Material Setup and Calibration
11
2.5.1
Solid Material Setup
11
2.5.2
Solid Material Calibration – Manual or Readback Gate
11
2.5.3
Solid Material Calibration – Auto Gate
12
2.5.4
Prewet and Anti-icing Material Setup
15
2.5.5
Prewet and Anti-icing Material Calibration
15
2.6
Material Catch Test
16
3
Set up for additional feature functions
17
3.1
Conveyor Forward and Reverse
17
3.2
Spinner Forward and Reverse
17
3.3
Spinner & Conveyor Forward and Reverse
17
3.4
3Boom Anti-ice (DLA)
18
3.5
Dual Spinner
18
3.6
Air Gate
19
3.7
Gate Readback and Automatic Gate
19
3.8
Lane Control
20
3.9
(4 knob) Spreader+1Boom Anti-ice
20
3.10
(4 knob) Spreader+3Boom Anti-ice
21
3.11
(4 knob) Spreader+Cross Conveyor
21
3.12
(4 knob) Spreader+3Boom Anti-ice + Cross Conveyor
21
4
Set up Profiles
22
5
Set up Joystick Operation
23
6
Set up Error Messages
25
7
Load, Retrieval Parameter and Clear historic error messages
27
8
Appendix – CS-660 System layout, Cable Drawings