Bosch Rexroth CS660 - Set up Joystick Operation

23/27
Bosch Rexroth Canada I March 2021 ı Revision 3.0
Manually adjust
Min/Max/Emg
values for each
mode&direction
Select Mode
and direction
CALIBRATION
Deflect stick to a
desired speed &
click each button
to save setpoint
Mode, direction, output
current for axis deflected
in RED in calibration mode
Configure custom
joystick mode names
Disable–power float OFF
Reset–Pfloat needs to
be re-activated once the
output is OFF.
Non Rst – Pfloat
automatically re-activated
once stick returns to
neutral.
OPTION LIST
No Prox–No prox sensor
PFloat2 –2
nd
P.flt On/Off
DmpLmt–On/Off
Emg Interlock– Puts
conveyor in pause once
EMG button is pressed
pushed
Msg Flash – Flash
message when dump limit
prox is triggered
Msg Rst – Message
disappears once
acknowledged till it is
triggered again
Msg Off – Msg disabled
Click to START
5 Set up Joystick Operation
A typical spreader system with joystick option consists of the following components:
Once the joystick function is configured the joystick icon would be displayed under SYSTEM:
Click on the icon to pop up joystick configuration screen to calibrate all modes and axis configured.