Bosch Rexroth CS660 - Load, Retrieval Parameter and Clear Historic Error Messages

27/27
Bosch Rexroth Canada I March 2021 ı Revision 3.0
Press & hold anywhere in
msgbox to clear
Bottom of the screen shows firmware
versions and parameter file last loaded
Error 44 – Prewet Wrong Control Mode, Auto-Null not allowed
Error 45 – Liquid Wrong Control Mode, Auto-Null not allowed
Error 47 – 70 Calibration Error. Check sensor or cable, recalibrate
7 Load or Retrieve Parameters and Clear Historical Error Messages
The operation requires an USB PROGRAM key. It allows users to load parameters from an existing
parameter file on the USB stick.
Load and Retrieve parameters
1. Tap on toolbox icon to pop up tool window in PROGRAM mode
2. Tap on Load Parameters
3. Select a file from the popup file window to load
4. Click on the “Select” or “Cancel” button to select or cancel
5. With joystick option users would be given option to keep existing joystick setup
6. Tap “OK” to reboot
7. Turn the unit off, and on again for the new parameters to take effect
To retrieve the parameters click on usb icon on the operator screen with a PGM key inserted.
Clear Historic Error Messages
With a PROGRAM key users can also clear all the historic error messages on operator screen.