Bosch Rexroth CS660 - Lane Control for Spreading Width Adjustment

9/27
Bosch Rexroth Canada I March 2021 ı Revision 3.0
Pulses/rev
in Auto
mode
Control mode
An extra
“push” to
overcome the
friction of a
heavy load on
the conveyor
when starting
from 0 speed
2.3 Ground Speed Calibration
1. Select speed icon to enter into the ground speed calibration screen.
2. Choose which calibration option best suits your situation. Automatic or manual.
Note: Highly recommended to use the typical vehicle speed during spreading. And a more accurate real
time GPS speed is preferred for more precise speed calibration.
2.4 Valve & Sensor Setup
1. Tap the icon for the function you with to null.
2. Select the control mode:
Spinner –Manual (default), Half Lane, One Lane
Conveyor/Auger – Auto (default), Open LP, Man-Spd, Manual
Prewet – Off, Fixed, V-Flow (default), Manual, Manual-SPD, Return Oil, Open Loop
Anti-Icing (Anti-icing) – Off (default), 1 Boom, 3 Boom, Manual %
3. Set correct conveyor sensor pulses/rev if Auto is selected.
4. Ensure the hopper is empty, and the truck is safe to operate.
5. Start the engine to achieve adequate oil flow.
Note: If the Auto mode is selected it is strongly recommended to run Auto Null.
Follow instructions for speed calibration
Enter number manually