Solenoid Nulling
1. Press “Calibration” button and press a mode button on the joystick to select a desired mode to adjust.
4. Deflect joystick slowly until the hydraulic actuator moves – press “Min” while the stick is deflected.
5. Move the joystick until the actuator moves at a safe maximum speed – press “Max”.
6. Repeat this for all axis’, directions and modes.
7. While in calibration users also have option to double click on any direction arrow to pop up fine tuning
screen, or click on “Stop” button again to save all changes.
To Next Page
Loading...
