DEUTSCH
ENGLISH
ITALIANO
ESPAÑOL
SVENSKA
FRANÇAIS
ENGLISH
3608870DD4/2015-09 |
ErgoSpin/CC-ErgoSpin Bosch Rexroth AG 103
/110
Appendix
Tab.25: Basic requirements according to the Machinery Directive 2006/42/EC, annex I
No. Requirement applied satisfied
General principles
1. Risk assessment and risk minimization X X
1. Basic safety and health requirements
1.1 GENERAL
1.1.1 Definitions X X
1.1.2 Principles of safety integration X X
1.1.3 Materials and products X X
1.1.4 Illumination – –
1.1.5 Design of machinery to facilitate its
handling
XX
1.1.6 Ergonomics X X
1.1.7 Operating positions – –
1.1.8 Seating – –
1.2 CONTROL SYSTEMS
1.2.1 Safety and reliability of control systems X X
1.2.2 Control devices – –
1.2.3 Starting X X
1.2.4 Stopping
1.2.4.1 Normal stop X X
1.2.4.2 Operational stop X X
1.2.4.3 Emergency stop X X
1.2.4.4 Assembly of machinery – –
1.2.5 Selection of control or operating modes – –
1.2.6 Failure of the power supply X X
1.3 PROTECTION AGAINST MECHANICAL HAZARDS
1.3.1 Risk of loss of stability – –
1.3.2 Risk of break-up during operation X X
1.3.3 Risks due to falling or ejected objects X X
1.3.4 Risks due to surfaces, edges or angles X X
1.3.5 Risks related to combined machinery – –
1.3.6 Risks related to variations in operating conditions X X
To Next Page
Loading...
