Bosch Rexroth HEDE 10-3 Series - Page 28

28/48 Commissioning
Bosch Rexroth AG, HEDE 10-3X, RE 30277-02-B/07.2016
3 Conrmparametervalue
▶ Briey press [●].
The parameter is displayed
again. The new setting value is
saved.
Set other parameters
▶ Press [▲] or [▼] until the requested parameter is displayed.
Finish parameter setting
▶ Press [▲] or [▼] repeatedly until the current measured value is
displayed or wait for 30 s.
The unit returns to the process value display.
If [C.Loc] is displayed when an attempt is made to modify a
parameter value, a parameter setting process is active via IO-Link
communication (temporary locking).
If [S.Loc] is displayed, the sensor is permanently locked via
software. This locking can only be removed using a parameter
setting software.
• Change from menu level 1 to menu level 2:
▶ Press [●] to get to the
menu.
▶ Press [▲] or [▼] until [EF]
is displayed.
▶ Press [●].
The rst parameter of the
submenu is displayed (here:
[rES]).