Bosch rexroth M1-16 Series - Page 12

12/54 Control blocks for mobile applications | Safety instructions
Bosch Rexroth AG, RE 64025-B/2021-08-12
WARNING
System/machine under pressure!
Danger tolife orrisk ofinjury, severe bodily injury when working onmachines
which have not been put toastandstill! Property damage!
 Switch off therelevant machine/system part and secure itagainst reactivation
according tothe parameters bythemachine/system manufacturer.
 Ensure that all relevant components ofthehydraulic system are depressurized.
For this purpose, observe theparameters indicated bythemachine/system
manufacturer.
 Please note that thehydraulic system might still be pressurized event after
separation from theactual pressure supply.
 Do not disconnect any line connections, ports orcomponents aslong
asthehydraulic system isunder pressure.
Escaping hydraulic fluid mist!
Risk ofexplosion and fire hazard, health hazard, risk ofenvironmental pollution!
 Depressurize therelevant machine/system component and repair theleak.
 Only perform welding work when the machine isdepressurized.
 Keep open flames and ignition sources away from the control block.
 If control blocks are located inthe vicinity ofignition sources orpowerful
thermal radiators, ashield must beerected toensure any escaping hydraulic
fluid cannot beignited, and toprotect hose lines from premature aging.
Electrical voltage!
Danger tolife orrisk ofinjury due toelectric shock orproperty damage!
 Always disconnect the voltage supply tothe relevant machine/system
part before installing the product and/or connecting ordisconnecting the
connector.
 Protect themachine/system against being re-energized.
Limitation ofthecontrol function!
Risk ofinjury orproperty damage!
Under certain circumstances, moving parts incontrol equipment (e.g.control
spool) can get stuck inan undefined position due tocontamination (e.g.impure
hydraulic fluid, abrasion orresidual dirt from components). As aresult,
the activated consumer does nolonger respond correctly tothe operator’s
specifications.
 Secure the machine against rolling away and accidental movements according
tothe specifications ofthe machine manufacturer.
 Comply with the prescribed cleanliness level ofthe hydraulic fluid
inaccordance with the datasheet.
Faulty power supply!
Danger tolife orrisk ofinjury due touncontrolled valve settings! These settings
can lead to unexpected behavior of the control block.
 Always connect the ground connection ofthe control block with the
corresponding grounding system ofyour installation.
 Only use apower supply unit with asecure disconnection facility. Observe the
country-specific specifications.