EasyManua.ls Logo

Bosch rexroth M1-16 Series - Page 13

Bosch rexroth M1-16 Series
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RE 64025-B/2021-08-12, Bosch Rexroth AG
Safety instructions | Control blocks for mobile applications 13/54
WARNING
Danger caused by pressurized, leaking hydraulic fluid!
Danger to life or risk of injury due toleaking hydraulic fluid streams! Leakage
atthe control block can lead tohydraulic fluid escaping under high pressure.
Depressurize therelevant machine/system component and repair theleak.
Never attempt toblock orseal theleak orhydraulic fluid jet with acloth.
CAUTION
Risk ofinjury due tosharp edges and rough surfaces!
Risk of injury when working with and transporting the control block, e.g. due to
sharp edges on the valve housing, on threads or assembled parts.
Wear appropriate personal protective equipment (e.g.safety shoes, safety
goggles, safety gloves and suitable working clothes).
Danger ofbruising and knocks forlimbs!
In the gap between the actuation element and the valve housing, there isarisk
ofinjury
Do not move any limbs into the gap between the actuation element/hand lever
and the valve housing.
High noise development during operation!
Danger ofhearing damage orhearing loss!
Among others, the noise emission ofcontrol blocks depends onthe working
pressure and the installation conditions. The sound pressure level may rise
toabove 70dBA under specific application conditions.
Always wear hearing protection when you are in the vicinity of the running
control block.
Hot surfaces on the control block!
Risk ofburning!
Allow the control block to cool down sufficiently before touching it.
Protect yourself with heat-resistant protective clothing, e.g. gloves.
Inappropriate routing ofcables and lines!
Risk ofstumbling and property damage! Due toincorrect routing oflines and
cables, both arisk ofstumbling aswell asdamage toparts and components can
occur, e.g.due tolines and connectors being torn off.
Always install cables and lines inaway that nobody can fall over them, that
they are not bend ortwisted, do not chafe onedges and are not guided
through ducts with sharp edges without sufficient protection.

Table of Contents

Related product manuals