Safety instructions 7/40
RE 30110-B/11.2012, VT-VSPA2-1-2X/V0/T., Bosch Rexroth AG
1.3.4 Abbreviations
The following designations are used in this documentation:
Table 5: Abbreviations
Designation Meaning
EMC Electromagnetic compatibility
PELV = Protective Extra Low Voltage
2 Safety instructions
2.1 General information on this chapter
The product has been manufactured according to the generally accepted code of
practice. However, there is still the risk of personal injury and damage to property if
you do not observe this chapter and the safety instructions in this documentation.
▶ Read this documentation completely and thoroughly before working with
theproduct.
▶ Keep this documentation in a location where it is accessible to all users at
alltimes.
▶ Always include the required documentation when you pass the product on to
third parties.
2.2 Intended use
The product is an electric component.
The VT-VSPA2-1-2X/V0/T* analog amplifier card is used for generating, linking or
standardizing command value signals and subsequent amplification of the generated
signals. You may use the product as follows:
• For controlling the valves specified in the data sheet 30110.
The product is only intended for professional use and not for private use.
Intended use includes having read and understood this documentation, especially
chapter 2 "Safety instructions" on page7.
2.3 Improper use
Any use deviating from the intended use is improper and thus not admissible.
Bosch Rexroth AG does not assume any liability for damage caused by improper use.
The user assumes all risks involved with improper use.
The following cases of foreseeable misuse are also regarded as being improper:
• Using the analog amplifier card outside the specified performance limits and oper-
ating conditions and in particular the specified environmental conditions.
To Next Page
Loading...
Need help?
General