24/40 Installation
Bosch Rexroth AG, VT-VSPA2-1-2X/V0/T., RE 30110-B/11.2012
7 Installation
CAUTION
Fault currents and short-circuits!
Impairment of safety and malfunctions.
▶ The environment must be free from electrically conductive contamination (acids,
bases, corrosive agents, salts, metal vapors, etc.) and the device must not be
exposed to these substances.
Cables lying around!
Risk of stumbling.
▶ Lay the cables and lines so that they cannot be damaged and no one can trip
over them.
NOTICE
Major potential differences!
Danger of destroying the amplifier card by plugging or unplugging while energized.
▶ Always de-energize the relevant system part before plugging, unplugging or
connecting the device. Damaged devices due to incorrect installation are not
covered by the warranty!
▶ Observe protection class, voltage supply and environmental conditions accord-
ing to data sheet RE 30110.
Electrostatic discharge!
Danger of destroying the analog amplifier card.
▶ Keep the amplifier card in its antistatic packaging until installation and comply
with the instructions on the top of the packaging when unpacking the device.
Interference!
Risk of malfunctions.
▶ The distance to radios must be sufficient (>> 1 m).
▶ Do not lay solenoid conductors and signal lines near power cables.
▶ Shield command and actual value cables. Shielding open at one side, connect to
system earth on the card-side.
7.1 Work steps
Perform the steps in the following order:
1. Plug jumper
2. Install card
3. Set command value
4. Set command value zero point
5. Set ramp times (internal/external)
6. Set step level
7. Set maximum values
To Next Page
Loading...
Need help?
General