Bosch RG8.0 - Cleaning the Particle Filter

F 002 DG9 H10 2018-08-21| Bosch Automotive Service Solutions GmbH
Repair | RG8.0 / RG4.0 | 17
en
6.19 Cleaning the particle filter
1. Execute the steps listed in chapter 3.1.
2. Unfasten the LP inlet port.
DIRECTION OF
AIR BLOW
1
2
H00_24NKV
4
3
Fig. 7: Cleaning the LP inlet port
1 LP inlet port
2 O-ring
3 Particle filter
4 Adapter
3. Notice the direction of blowing air from the air gun
indicated in Fig. 7. Clean the LP inlet port using a
blower. Do not use a pressure of more than 2 bar.