Bosch SLDA - Map View Customization; Map Scale, Modes, and Location Selection; Route and Location Details

112 | en
s Clock time
t Distance to the destination
u Estimated arrival time
v Estimated time to the destination
7.7.3 Repeating the current naviga-
tion announcement
f During active route guidance, tap the driving
manoeuvre symbol in the map view q.
7.7.4
Changing the map scale
To increase or decrease the map scale when in
map view,
f tap h or r.
Note:
If automatic zoom is enabled (see the
section entitled “Enabling automatic
zoom” (page 116)): If you manually
change the map scale, the automatic
zoom function is suspended for around
30 seconds.
7.7.5
Changing the map view mode
You can choose whether
f the map aligns with north (in this case, north
always appears at the top in map view),
f the map always aligns with your heading (in
this case, the area that lies ahead of the
vehicle always appears at the top in map
view),
and whether
f a 2D map is shown or
f a 3D map is shown.
f In the map view, tap the compass x to
switch between these modes:
– 3D map aligned with the driving direction
– 2D map aligned with north
– 2D map aligned with the driving direction
Notes:
f You can also change the map orien-
tation in the navigation and map
settings (see the section entitled
“Selecting the map orientation”
(page 115)).
f You can also activate the 3D map
view in the navigation and map
settings (see the section entitled
“3D map view – on/off” (page
115)).
7.7.6
Changing the displayed sec-
tion of the map
During active route guidance, you can choose
whether
f the map should show the entire route or
whether
f the map should show the area around the
vehicle.
f In the map view, tap the button i to switch
between the modes.
7.7.7
Selecting a destination or
waypoint from the map
You can pick a location shown on the map as a
destination or waypoint.
f Long tap the location on the map.
If a route guidance session is active, you can
f replace the current destination,
f set the location as a waypoint.
To do so,
f tap Replace destination or Add as way-
point.
If no route guidance session is active, you can
set the location as your destination.
f Tap Set as destination.
The system calculates the route to the new
destination.
7.7.8
Viewing details of a location
on the map
f Tap the location on the map.
f Tap Details.
The details view of the location is displayed (see
the section entitled “Location details view”
(page 109)).
Navigation