NL Troubleshooting
Malfunction Cause and Troubleshooting
"E:36 / -10" Unauthorized extension mounted on the water drain
hose.
▶ Remove unauthorized extensions to the wa-
discharge hose. Connect device
Pump cover is not fully screwed in.
▶ Make sure that the pump cover is up to the stop
screwed into the device. The pump cover handle
must be vertical.
→
"Cleaning the drain pump", Page 44
"E:36 / -25 / -26" Drain pump is clogged.
▶ → "
Cleaning the drain pump", page 42
"E:10 / -00 / -10 /
- 20"
Pump of the intelligent dosing system is blocked.
1. Switch off the device.
2. Clean the pump unit.
→
"Cleaning the detergent drawer",
Page 41
3. If the indication reappears, enable the service.
→
"Service", page 58
Remark: You can start the washing program if you
deactivate the intelligent dosing system and dose
manually.
→
"Keys", Page 24
Water pressure is low.
No solution possible.
Strainer in the water supply is clogged.
▶ Clean the strainer in the water supply.
Water tap is closed.
▶ Open the water tap.
Water supply hose is kinked or pinched.
▶ Make sure that the water inlet hose is not
nods or clenches.
"E:35 / -10" Water in the bottom tray.
▶ Close the tap.
▶ Please contact customer service.
→
"Service", page 58
Device is leaking.
▶ Close the tap.
▶ Please contact customer service.
→
"Service", page 58
46
To Next Page
Loading...
