Troubleshooting NL
Malfunction Cause and Troubleshooting
The program duration
changes during the
wash cycle.
Remark: When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Foam control system will add an extra rinse if the
foam is too high.
▶ No error - no action required.
The water is not
visible in the drum
bar.
The water is below visible range.
▶ No error - no action required.
▶ Do not fill any additional water into the appliance during operation.
honeycomb.
Drum jerks after
program start.
The cause is an internal motor test.
▶ No error - no action required.
Vibration and movement The appliance is not leveled properly.
of the appliance
during the spin
run.
▶ Adjusting the device
Device feet are not fixed.
▶ Secure the device feet. Setting the appli-
raat
Transport protections have not been removed.
▶ Remove transport locks
Drum is spinning, er
no water flows into
the appliance.
Load recognition is active.
▶ No error, no action necessary.
Remark: The load detection can take up to 2 minutes.
strong foam Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
ter with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
ming.
▶ When the intelligent dosing is activated, re-
then induce the basic dosing amount
→
Page 36.
▶ When dosing manually, reduce to the full
next wash with the same load the amount of
detergent.
i-DOS i-DOS Intelligent dosing is not possible for this program.
▶ No error - no action required.
cannot be pressed
Program progress does not allow intelligent dosing.
No solution possible.
51
To Next Page
Loading...
