de Troubleshooting
disturbance
Wrinkling.
Cause and troubleshooting
Spin speed is too high.
▶
Set a lower spin speed for the next wash cycle.
Load is too high.
▶
For the next wash cycle, reduce the load.
Unsuitable program set for the type of fabric.
▶
Select suitable programs for the type of textile.
Detergent or
Fabric softener is dripping off
the cuff and
collects on the door
or in the cuff.
Too much detergent / fabric softener in the detergent
drawer.
▶
When dispensing liquid detergent and fabric
softener, pay attention to the marking in the
detergent drawer and do not dispense above it.
Spin result is
not satisfied-
lend. The laundry is
too wet / too damp.
The low spin speed is set.
▶
Set a higher spin speed for the next wash cycle.
▶
Start the program Fling.
The drain pipe or water drainage hose is blocked.
▶
Clean the drain pipe and water drain hose.
The drain pipe or water drainage hose is kinked or
pinched.
▶
Make sure the drain pipe and water drain hose are
not kinked or pinched.
The unbalance control system has stopped spinning
due to uneven distribution of the laundry.
▶
Redistribute the laundry in the drum.
Notice: Place large and small items of laundry
together in the drum. Laundry items of different sizes
are better distributed during spinning.
▶
Start the program Fling.
The unbalance control system compensates for unbalance
by reducing the spin speed.
▶
Redistribute the laundry in the drum.
50
To Next Page
Loading...
