User manual WTS Ver.1.16
Seite 23 von 52
By confirming with the setpoints operation can be set to the value ‘0’:
-
: relay switching will not occur if the setpoint value is ‘0’.
-
:
- Setpoint = ’0’ and
=
, relay switching occurs when the weight is ‘0’; the
relay will switch again when the weight is different from zero, taking hysteresis into
account (both for positive and for negative weights).
- Setpoint = ’0’ and
=
, relay switching occurs for a weight higher than or
equal to ‘0’, the relay will switch again for values below ‘0’, taking hysteresis into
account.
- Setpoint = ’0’ and
=
, relay switching occurs for a weight lower than or
equal to ‘0’, the relay will switch again for values above ‘0’, taking hysteresis into
account.
INPUTS
Default: input 1 =
input 2 =
Possible operation modes:
-
(NET/GROSS): by closing this input for no more than one second, it’s making an
operation of SEMI-AUTOMATIC TARE and the display will show the net weight. To display
the gross weight again, hold the NET/GROSS input closed for 3 seconds.
-
: by closing the input for no more than one second, the weight is set to zero (see
paragraph SEMI-AUTOMATIC ZERO (WEIGHT ZERO-SETTING FOR SMALL
VARIATIONS)).
-
: keeping the input closed the maximum weight value reached remains on
display. Opening the input the current weight is displayed.
-
: closing the input no operation is performed, the input status may however be read
remotely by way of the communication protocol.
-
: closing the input for max one second the weight is transmitted over the serial
connection according to the fast continuous transmission protocol only once (only if
is set in the item
).
-
: when the input is closed the weight is displayed based on the set coefficient (see
setting of the units of measure and coefficient), otherwise the weight is displayed.
To Next Page
Loading...