Bowa ARC 300 - Menu Program 10 Restore Programs; Menu Program 11 Panel Check

6 Operation
900-350_IFU_V2.6_10296-S13-20100111-EN ARC 300 / ARC 350 Operating manual 63
6.4.12. Menu program 10 "Restore Programs"
In the menu program “Restore Programs”, all standard program
parameters which have been changed in the HF device will be reset to
the factory settings.
1. Press the power limitation key for monopolar cutting 4 to reset the
standard programs (0-23).
2. Press the key/display for AUTOSTART 32 to confirm the reset.
ª
After the restoration procedure has been completed, the program
automatically returns to the menu programs.
6.4.13. Menu program 11 "Panel Check"
In the menu program “Panel Check”, all lighting components on the
operating panel are activated.
1. Press the power limitation key for monopolar cutting 4 to activate
all lighting components.
2. Press the power limitation key for monopolar cutting 3 to return to
the menu programs.
Pos: 40 /679-BOWA/ARC 300/35 0/8 Fehler/8 Fehler erkennen und beheben @ 4\mod_12 61040652788_6.doc @ 35128 @ 1