Bowa ARC 300 - Assigning a Foot Switch Output

5 Preparation
900-350_IFU_V2.6_10296-S13-20100111-EN ARC 300 / ARC 350 Operating manual 37
5.3.4. Assigning a foot switch output
1. Press the key/display for “Monopolar output 2” 39 for 1.5 seconds
–or–
the key/display for “Bipolar output 3” 44
–or–
the key/display for “Bipolar output 4” 48
–or–
press the additional key on the double pedal foot switch (e.g. for
the “Bipolar output 3 or 4”).
ª
The message "SEt PEd." appears on the "Monopolar Cut" display 2
and the "Monopolar Coag" display 9 and an alternating signal
sounds that confirms the switching process acoustically.
2. Press the key/display for AUTOSTART 32 for longer than 5
seconds.
ª
The configured HF parameters will be saved and the symbol ->
appears on the display/main display 15.