Treadmill 10 and 22: How do I fix a "Belt Overspeed" error?
Follow this troubleshooting guide to help resolve "Belt Overspeed" error messages on the BowFlex Treadmill 10 and Treadmill
22.
Some common complaints may include:
Belt Overspeed error on console
Error message displayed on console
Belt speed above user set speed
Speed changes without input
Follow these steps to troubleshoot the issue
The "Belt Overspeed" error is caused by either the belt being moved while the treadmill is powered onbut outside of a
workout or when the belt is moving faster than the speed set by the user.
Troubleshooting steps depend on if the error appeared during a workout or if it appeared while the machine was not in use:
Error appeared during a workout
1. This is most common when the treadmill is set to a high incline and low speed; the user's body weight can cause the
belt to accelerate.
2. If you were in a workout when the error appeared, your workout will be saved and the console may reboot to the "Bel
Overspeed" error message.
3. To clear the "Belt Overspeed" error, power cycle your treadmill using the main power switch on your machine. The
error should clear after turning the power back on. Adjusting the incline/speed settings to match your pace and
preventing belt movement outside of a workout should keep the error message from returning[14704.A].
Error appeared when machine was not in use
1. A "Belt Overspeed" error can be caused by a user intentionally moving the belt outside of a workout.
2. If the belt needs to be moved manually, the machine should be powered down before doing so to prevent the error
from appearing.
3. To clear the "Belt Overspeed" error, power cycle your treadmill using the main power switch on your machine. The
error should clear after turning the power back on[14704.B].
4. If the user was not intentionally moving the belt, the screen is dark, and the belt moved without user input,order a
Motor Control Board (MCB) [14704.C].
ID:14704.1
To Next Page
Loading...
