Treadmill 10: How can I prevent electrostatic shock?
Follow this troubleshooting guide to help resolve issues involving electrostatic shock on the BowFlex Treadmill 10.
Some common complaints may include:
Static shock
Electrostatic shock
Static electricity
Follow these steps to troubleshoot the issue
Tools you may need:
6mm hex/Allen wrench, or the wrench from the hardware
card included with your machine
1. It's not uncommon for static to build up on any machine with a moving belt. Our machines are designed to properly
minimize static build-up. If you are experiencing static build-up, try one or more of the following to help reduce static
[11406.A]
Avoid wearing loose or baggy clothing while using your treadmill.
Put long hair up in a ponytail
Wear a treadmill anti-static wristband or strap
2. Lubricate your machine according to intervals outlined in the service manual. Instructions on lubricating your
machine can be found here:Treadmill 10: I need help lubricating my treadmill[11406.B].
3. Unplug your treadmill from power and check the plastic covers that extend over the walking belt. Make sure that the
covers are not rubbing on the belt. If it is, refer to the "Adjust the Walking Belt" procedurein the service manual,
adjusting until the covers are no longer rubbing on the belt[11406.C].
4. Ensure that your treadmill is plugged into a properly wired 3-prong outlet. It is not recommended to use an extension
cord for your treadmill. You can test your outlet using another device, such as a lamp, and seeing if it turns on. You ca
also test using a receptacle tester from your local hardware store. Switch to another outlet if the original outlet is not
working or wired properly[11406.D].
5. Clothing made from synthetic fibers generate static electricity more frequently than clothing made from natural fibers
Synthetic fibers include polyester, nylon, spandex, etc. We recommend wearing clothing made from natural fibers,
such as cotton, linen, or wool, to reduce static charge build-up[11406.E].
6. Dry air conditions may also contribute to static charge build-up. Heaters and air conditioners tend to remove moisture
from the air. Increase the humidity in your workout area to the recommended range of 45 to 65 percent
humidity[11406.F].
7. Clean or dust off the bottom of your shoes before beginning a workout. The dirt, dust, and hair that may accumulate
on your shoes creates friction with the belt and may build a static charge. If any dirt, dust, or hair is seen on your
treadmill, wipe with a clean, dry cloth to remove[11406.G].
8. If the above tips fail, you can try an anti-static spray that can be applied to the walking belt of your treadmill and your
workout clothing. The spray works by adding moisture to the air and making the surface area less conductive. If your
treadmill is located on carpet or a rug, it may help to spray the carpet or purchase an anti-static mat [11406.H].
ID:11406.1
To Next Page
Loading...
