Brady i5100 - Page 34

32 BradyPrinter i5100
Invalid setup The Setup menu is incorrectly config-
ured.
Cancel the current job. Recheck all
configuration settings.
Memory overflow Current print job contains too much
information, e.g. selected font, large
graphics.
Handshake mode is not on.
Cancel current print job.
Reduce amount of data to be printed.
Access the printer setup menu, hand-
shake mode and select RTS/CTS.
Multiple Label Tags
Found, Remove
Extras
Multiple tags on core of IP-enabled
label material or printer did not clear
from last tag read.
Reboot printer to get a fresh read of
supply. If error reoccurs select Enter
to bypass and use Standard mode.
Multiple Ribbon Tags
Found, Remove
Extras
Multiple tags on core of IP-enabled
label material or printer did not clear
from last tag read.
Reboot printer to get a fresh read of
supply. If error reoccurs select Enter
to bypass and the printer will
load primary ribbon settings for Brady
mode.
Multiple Tags Read
Remove Extra Tags
RFID tags on an IP-enabled roll of
labels read incorrectly.
Remove and reinstall the label spool
and/or the ribbon spool. If the error
does not clear, recycle power to the
printer.
Name exists Duplicate usage of field name in the
direct programming
Correct programming
Network Error,
No Link
Ethernet is selected in the setup
menu but no Ethernet connection.
Check that the Ethernet server is
available and connected, then recycle
power to the printer.
or
Go to the settings menu and turn off
Network Error reporting, then recycle
power to the printer.
No label found There are labels missing on the label
material
Press Repeat repeatedly until printer
recognizes the next label on the
material.
The label format as set in the soft-
ware does not correspond with the
real label format.
Cancel current print job.
Change the label format set in the
software.
Restart print job.
Printer is loaded with continuous
paper, but the software is set on
labels
Cancel current print job.
Change the label format set in the
software.
Restart the print job.
Missing RFID Tag Select Enter to bypass error and use
in Standard mode.
No label size The size of the label is not defined in
the programming/software.
Check the software programming.
Error Message Cause Corrective Action