Brady IP Printer series User Manual

Brady IP Series Printer
Replacing assembly units
Edition 12/07 Service Manual 13
2.7 Replacing the printhead
Fig. 6: Replacing the printhead
1. Open the cover and hinge down the control panel, press the release button and hinge up the print
module.
2. Disengage the printhead (4) from the printhead mounting (6) by unscrewing the screw (3).
3. Remove the printhead cables (5) and (7) from the printhead (4).
4. After exchanging the printhead (4), attach the printhead cables (5) and (7) to the new printhead.
5. Attach the printhead (4) to the printhead mounting (6) by the screw (3)..
6. Hinge down the print module and press evenly on the two marked surfaces so that the unit snaps in
on both sides. Close the control panel.
DANGER!
Danger to life and limb from electric shock!
⇒ Disconnect the device from the mains supply.
1
Two holes
2 Two pins
3 Screw
4 Printhead
5 Printhead cable
6 Printhead mounting
7 Printhead cable
4 5 761 32
CAUTION!
Protect the printhead against damage by electrostatic dischargement!
⇒ Put the printer on to a grounded conductive surface!
⇒ Ground yourself during printhead replacement for example using a grounded wrist-strap!
⇒ Do not touch the connector pins of the printhead by naked hands!
NOTE!
Ensure that the pins (2) at the printhead reach into the holes (1) of the printhead mounting.

Brady IP Printer series Specifications

General

Brand	Brady
Model	IP Printer series
Category	Printer
Language	English