CHAP.7 – USE OF THE INSTRUMENT 32/ 32 ENGLISH
ags-200
7.1.1 GAS READING IN CONTINUOUS MODE
Access the main menu of the EXHAUST GAS ANALYZER and press F1
"CONTINUOUS TEST"
This accesses the CONTINUOUS TEST mask.
The gas reading can only be made at the end of the warming up period and the auto-
calibration procedures.
The following parameters are displayed in this mask:
- GAS VALUES: CO, CO2, O2, HC, NO (optional)
- CORRECT-CO,
- LAMBDA factor
- Engine oil temperature
- Engine rpm
- Vehicle data
To Next Page
Loading...
