BRANNSTROM BilgMon488 - Information Menu

BilgMon488 Instruction Manual vAD 20(38)
BRANNSTROM SWEDEN AB
www.brannstrom.se
10.8 INFORMATION MENU
The information submenus will display
5
information about the MASTER and the SENSOR unit of
BilgMon488 according to examples below:
10.8.1 Master info
Cycle 0:
Menu name.
Cycle 1:
Serial number.
Cycle 2:
Software version.
Cycle 3:
Master unit lid power supply voltage. Should be approx.
5V.
Cycle 4:
RTC backup battery voltage. Should be approx. 3V. If
lower than 2.5V, replace battery ().
Cycle 5:
Internal time reference (RTC). Should be UTC time and
date (approximately).
10.8.2 Sensor info
Cycle 0:
Menu name.
Cycle 1:
Serial number.
Cycle 2:
Software version.
Cycle 3:
Factory calibration date.
Cycle 4:
Calibration check date.
Cycle 5:
SENSOR internal measurements (temperature, moisture,
voltage etc.).
5
Information is continuously cycling (cycle 0, cycle 1, … , cycle n, cycle 0, …).
Master info
Master ID:
000A-4567
Master SW ver:
00C3
Master voltage:
5V supply=5.3V
Master voltage:
RTC battery=3.0V
Master UTC:
140427 18:23:34
Se nsor info
Se nsor ID :
00 0B-4325
Se nsor SW ver:
00 B6
Se nsor da te:
14 0112 13 :23:10
Ca l. checked:
14 0427 10:43:12
T:25.3 Dry:60
V3:3.20 V03:.312